What are the processing requirements for copper bars
12
The copper bar processing technology is very strict. If you do not pay attention to some details, unnecessary troubles may occur, so what are the copper bar processing requirementsLet’s take a look at the introduction of the copper bar manufacturer: When scribing the copper bar, it is necessary to make a reasonable line according to the position of the hole to reduce unnecessary lines; pay attention to the strength of the hand to make the surface of the copper bar free of scratches; see clearly on the drawing Marked size, aperture size.When cutting the copper row processing machine, we should cut the material according to the specifications of the copper row processing machine; before blanking, use a caliper to measure the width and thickness of the copper row.Unload the material after confirming that it meets the requirements; place the lower copper rows neatly to avoid scratches.When the copper bar needs to be tapped, it is necessary to determine whether the hole diameter of the bottom hole meets the requirements, and then select the corresponding tap tap.When drilling holes, you should see the size of the hole in the copper row, and use a drill of the corresponding size to drill; the copper row should be placed neatly after drilling; the operator should not wear gloves when drilling, and the hand should be with the drill bit. Keep a certain distance between them to ensure their own safety.The specifications of the pressure riveting insert of the copper row processing machine and the surface of the copper row are required; the appropriate pressure is selected on the pressure riveting machine to avoid excessive pressure and the copper row is crushed; the surface of the pressure riveting machine or the copper row needs to be protected, Avoid scratching and crushing the copper bars.The copper bars should be selected according to the corresponding molds of different thicknesses; after the molds are adjusted, scrap test knives must be used to avoid the production of defective products; the bending operator should do a self-inspection after the folding is done.After confirming the qualification, give the inspector to do the inspection. Copper busbar is a high-current conductive product, suitable for high and low voltage electrical appliances, switch contacts, power distribution equipment, bus ducts and other electrical engineering projects. It is also widely used in metal smelting, electrochemical plating, chemical caustic soda and other large current electrolytic smelting projects.In summary, the processing requirements for copper bars are still very strict, so be very careful when processing. Yueqing Renhe Electronics Co., Ltd. is a professional copper bar manufacturer in Zhejiang, focusing on the production, research and development of new energy electric vehicle battery copper bar connection, electrical connection copper bar, braided copper bar, flexible copper bar connection, cable connection and insulating protective cover And sales.Products comply with EU environmental protection, UL flame retardant, ISO9001 management system certification requirements.