Temporary controller adjustment problem
Single school: Power supply to the controller to disassemble the resistor’s wire (usually three -line system) to receive the resistor box (two wires are connected to one end, one section one by one, how to see the circuit Electric Filter Fan Cabinet Heater Fan Heater with Thermostat diagram on the controller, or you master the third -line power production makingThe bridge will understand how to pick it up)
Adjust the resistance table of the control resistance body to see if the header shows whether the corresponding thinking is that the output current signal corresponds to the corresponding range.
Of course, before the disassembling resistance, the header is displayed by the way.
United school: directly hang the Hart hand operator for a loop test LOOP TEST to see if the control room corresponds to the corresponding school pairing process.
Exit the circuit test to see if the control room is displayed at room temperature (these are completed before driving, and the temperature of the empty can is generally normal temperature)