Temporary controller application characteristics
The temperature controller is a closed temperature control switch developed by thermal dual -metal development. It has the characteristics of rapid movement, accurate temperature control, large control current, and long service life. Wait for temperature protection control.
Connect the elastic element with environmentally friendly silver contacts on the bottom plate. The bottom plate and spring chip are equipped Electric Filter Fan Cabinet Heater Fan Heater with Thermostat with a dual metal disc that are induced, embedded in the shell, and the heat is passed to the dual metal sheet to reach the specified value of the dual metal sheet to reach the specified value of the dual metal sheet. It instantly moved, and the circuit was cut off. When the temperature dropped to the reset temperature, the dual metal closed quickly, and the circuit was connected again.
Application in the aspects of overheating:
1. Various motor/microcomputer 2. Electric cooker 3. Town flow device 4. Electric heating belt 5, health equipment 6, electric heating appliances 7, water pump 8, exhaust fan 9, vacuum cleaner 10, electric tool 11 battery 12, various electric heating products, etc. Wait.
Materials outside the product
PBT high-temperature plastic shell is the same as the SEKI ST-22 size in South Korea
PBT high -temperature plastic shell
Wiring: PVC line or high -temperature silicone wire.
Divided according to the nature of the action: it can be divided into normal opening, and normally closed actions.
Precautions for temperature controller
1. When installing a temperature -like installation, the product should be tightly installed.
2. During installation, you should not be crushed or deformed by plastic or metal cases to avoid affecting performance.
3. The metal shell product has a plus insulation jacket. In the installation, it cannot be removed or broken, which can be removed or broken to avoid leakage and ensure the safety of use.
4. The product is used in a circuit with a current of not greater than 5A. The copper core section should be connected to the 0.4-0.75㎜2 wire.
5. The product should be stored in places where the relative humidity is less than 90%and the ambient temperature is below 40 ° C. Ventilation, clean, dry, and corrosive gases.