For Composites Excellence (ACE) from the American Composits Manufactures Assn. (ACMA, ARLINGTON, VA.)
Tradingal SMC Door Skin Mold Can Cost as Much as $ 300,000, "Say Our Process Can GIVE You A Finished Door, With a Mold Costing $ $ 25,000, in One Shot."
To escape Through the Open Cells and Out of the Mold.
Matrix, Causing Some of the Resin to Invade Adjacent Foam Cells as they Crush Slightly Under Pressure.
Accessible Process, with a Wide Operational Envelope at a nominal Capital Cost.
Tailored Panels, Thick Or THIN, AT Low Cost with NO Additional ManuFacturing, Like Bonding Or Fastening, Needed. "
(with mold stops) to avoid overcompression.
Tooling Options are possible, but the caseing method propuces reasonably priced too, typically 0.75 INCH (20 mm to 25 mm) Thick.
is Placed on the Mold Followed by Layer of Glass-Filled SMC, Cut to Network, Which is laid flat over the prepared mold.
THEN A 1-Inch/26-THICK PIECK PIECE of Acell Foam, Also Cut to Network, is laid over the smc. A Second Layer of SMC is laid over the foam, along with a second veils, to facilitiesRerererererererererererereatedStep 6. After the Press Cycle, The Platan Shutter and the Part is Extracted.
Trimmed to the exact size and easily account the mounting hinges and hardware.
MOLDING PANELS (See Photos), where the thermal insulation, Uv Resistance and Impact Resistance of the Process Shines.