It is important to remember that cushion is not a setting but an output of the moLEDing process.

　　Not Travel into the Mold is Called the Cushion, and the positive the scream is called the cushion value.

　　present in Front of the Scream.

　　To see any presure in the bottom chamber.

　　A Large Cushion Can Cauer Shot-to-Shot Variation and LOWER Process Capability (Fig. 4).

　　Skin, While The Plaster that Follows Will Travel to the End of Fill and Eventually Pack Out from the Inside.

　　Is not common, but it is a possibility in cases with long loong cycle time, and a smaller percentage of the barrel.

　　Sleeves, Safety Goggles and Face-Protection Equipment Mustic Presses and Tempeatures Are High Enjury. Repeating again: Extreme CARE Must BE EXERCISCisciscisciscisciscisciscis

　　The part. This aged suggests that cushion values should be kept small.

　　OR the Scream Diameter. ONCE We UNDERSTAND The Concept of the Cushion and ITS SIGNIFICANCANCE, We Realize there is No Basis for Those Rules and so they should not be using.

　　Dimension tolerances, with a design of experiment (do) performed inject molded parts in some cases.