High multiply tooth squeezing the radiator process and it ::
1. When testing the aluminum mold, the first time must be a short pure aluminum aluminum aluminum stick with 150-200mm
2. Before testing the model, the center of the center of the center of the center must be squeezed out.
3. In the process of harmony, the temperature of aluminum bars and aluminum rods must be guaranteed to be in
4. The aluminum profile mold is at the temperature, 480 ° C, and the flat mold thermal insulation and thermal insulation time below 200mm below 200mm. 6 hours to ensure the core and temperature. Essence Essence
5. Before production, you must use clean inner orchy bilots, and squeeze in the inner bilirus of the tube tube
6. When the model test is just, the squeeze is dropped, each off, and each section returns to zero. Essence Start pressure from the smallest little pressure, small temperature controller starting pressure, pressure, pressure, 3-5 minutes, 3-5 minutes, within 100kg/cm2 aluminum, within 2-3A, 80-120kg/cm2 can be released material.
7.铝合模具模具试模中中中中中中中中中中过程堵模，偏齿，，快慢快慢偏差偏差偏差偏差太太太大大大现象时时要要要立刻
8. In the process, in the outlet, the disagreement port is smooth, and the cushion or elasticity is reasonable and reasonable according to the condition. I found it at any time and found that abnormal abnormalities PTC Heater and abnormalities
9. Straighten, be serious, operate, operate, work hard, strictly maintain
10. According to the production requirements, it is reasonable, cutting, sawtooth cutting, jagged cannot, avoid, avoid, avoid, end, end, remove, remove, remove positive
11. Aluminum type must be standardized, including placing, avoiding, avoiding. Essence Essence Essence
12. Aluminum-type aluminum profiles are released at 190 ± 5 ° C and 2.5-4 hours. Essence Essence Essence