Let ’s Go Through All the Components in a Bit More Detail:
Solar Panels ABSORB SunLight and Generate Direct Current (DC) Electricity. They do this by use the ‘PV Effect’ Described Above.
This is a switch that can disconnect the panels from the inverter. It was a required bit of kit, as per the Australian state (as5033) – More on the "was" below.
It is a stupid device, unique to Australia.
- Bad Things are gonna happen.
However, where a rooftop dc isolator is not installed, a "disconnection point" is required, and that involves other association requirements relating to capable routing, the documents and lighting.
If you want to go with excellent one, a cheap installer may be unwilling to do the extra works under the revision standard.
Good, Modern Inverters Now Come with A Built-in DC Isolator, Which is a lot nexter and presents less risk of badnections or water
This device takes the ‘raw’ dc electricity from the panels and spits out 230V Accessricity; the form that your home can use.
The Switchboard contains the breakers for every circuit in the house. It is where the grid, and your Solar Inverter, connector into your home.
Your Installer Will Need to Add a Circuit Breaker for the Inverter Here. Ideally, they’l Add A ‘Consumpting Monitor’ AS WELL.
If your Switchboard is Small, or Old, Installing a Solar Power System May Also Require A New Switchboard. This ADDS APProximately $ 1200 in Costs.
Solar Inverters, Out of the Box, only have "product monitoring". This shows you How much Electricity Your System Has Generated On A Given Day.
A Photovoltaic Dc Circuit Breaker Consumping Monitor is a Small Box of Electronics that Goes in your switchboard. It gives you – Wait for it — Full ‘consumption monitoring’.
This means you ’ll be far to see not only what your solar system has fairated, but what your home has used as well.
Then, then
Talk to your solar inferter, meaning it doesm.
On a solar home, this meter is only useful to the electricity retailerphotovoltaic dc circuit breaker.