Electronic radiator requirements for quality and use

Regarding the environmental conditions of the surface quality of the electronic radiator
1.1 The heat dissipation should have no, cracks, etc.;
1.2 The fastener of the tablet, the plate -shaped disc shape, the water -cooled heat sink
1.3 The maximum allowable value of the roughness and roughness of the heat dissipation is Industrial Electric Fan Heateras a allowable value to be as the allowable value
1.4 The flatness of the heat dissipation is not less than level 9;
1.5 The radiator of wet tropical semiconductor devices ((standard; (standard; standard;
1.6 The insulation of the fastener of the radiator should conform to the compliance that meets the compliance (using the stretch parts
1.7 The firing tone of the heat sink should comply with the provisions of the product standard of the product;
1.8 Tablet Thermal Class Installation Center Positioning: Diameter and diameter: 2.5mm, high LMMO high on the table
Environmental condition requirements
2.1对水水质应有一定一定要求循环水的应应应2.5KI2，pH值6} 9之间；；；；；；；；；；；；；；；；；进口进口进口进口进口进口水水水水水水水水水温度温度温度温度温度温度温度不不高于高于高于高于高于automatic temperature control thermostat 高于高于高于高于高于高于高于高于高于高于高于高于Higher than higher than higher than higher than higher than higher than higher than higher than 35 ° C
2.2 When high or voltage devices, the above water quality requirements or high water quality must
2.3 When water is scattered, you should pay attention, Essence Essence
2.4风冷散热器，散热器散热器沿冷却方向；进口空气空气温度温度不不不高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于进口进口进口；；；；；高于；高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于高于时时时
2.5 Due to the characteristics of the cold and cold parameters, two parameters are used to block the wind.