Automatic baler is a kind of packaging machine that is more frequondens, you can package easily broken products, and the effect after packaging is very good, and you are welcomed by many customers. A machine is inevitable during long-term use, and the automatic baler is also like this. It has high usage frequencies, and there will be some small problems, and some are can’t solve, some can solve it. Today, Shanghai Bohui Xiaobian organizes the common faults and processing of the automatic baler, take a look.
First, the automatic baler has an abnormal sound
This is a very common problem. This problem is mainly a new machine and running machine. This is because the machine’s parts lack lubricant, you need to check it it yourself, see if it is a machine, Bearings, pulleys lack of wear caused by lubricants, if not, you need to contact maintenance personnel;
Second, the automatic baler is strapping
There are two reasons, one is that the user has not wear it when we wear. At this time, customers need to check if they don’t wear it when wear, and adjust the straps; Second, there is a foreign body card Live, causing the machine to be unsuccessful, check if there is foreign matter, do not need to contact the maintenance personnel;
Third, the item is touched
This situation may be that there is a problem with the placement of the packaging. It is necessary to adjust the position of the package. In addition, the package is too small, causing this situation. If not, you need to contact the maintenance person;
Fourth, do not cut after tightening
The reasons why it will cause this as follows: 1. The tight jump of the machine is a bit tight; 2. The heating cutting knife of the machine is broken, which requires contact for maintenance personnel; 3. Slip or skid skin with oil, must be removed Drop oil
Five, cassette processing
When the belt card is in the middle of the roller, or when there is a foreign body, the hexa nut is removed, the hexa nut is removed, loosen the two M5 countersunk screws on the middle connection axis, and since the two screws are fixed in the connection axis The gap portion, so you must turn the screws; remove the connecting axis, pick up the upper turn, take out the card. Finally, it is possible to assemble the recovery in the above manner, and the nut is maintained at a gap between 0.3-0.5mm with the L-type curve.
Six, packing with bandage
There are two reasons for this situation: It is necessary to contact maintenance personnel; Need maintenance personnel debugging;
7. Packing the bonding effect is poor
1. Too high or not enough, sometimes more special straps, poor viscosity, temperature must be very accurate;
2. It is not enough to use, there are many factories, often insufficient, if the extension line or cable is used, cause pressure drop, so that the original adjustment temperature becomes low, even the motor is burned, so try to avoid using the cable as much as possible Line, if you must use an extension line, you must be connected to the wire;
The above is the common fault and processing of the automatic baler, and it is desirable to solve the case where the user appears when the user is using the automatic baler. Shanghai Bofi Packaging Machinery focuses on the manufacture of packaging equipment, welcome customers to consult.