In FineBlanking Presses, A V-Ring is Incorporald Into One of the High-Pressure Pads. This v-ring also is commit referred to as a stinger or impiment raing.
Then, then
Produces a Smoolh-EDGED part that can be held to very tight dimensional tolerances (Figure 3).
ONCE AGAIN, Keep in MIND that gripflow is not a metal cutting process but a cold extruding process. The cutting section of have cutting shear group on them.
Process is best-suited to a hydraulic action present.
. Keep in Mind that Each Process Has ites own Advantages and Disadvantages.
Gripflow Blanking Die is a registered trademark of ebway corp.